Hello everyone,

I have been experiencing an issue with the rack focus response time from my CTRL.3 controller to my motorX. Despite having the response time set to ‘F’ (Fast), there seems to be a noticeable delay before the motor catches up with the knob adjustments. This is causing a bit of a lag in achieving precise focus during critical moments.

Has anyone else encountered this issue? Is there a particular setting or firmware update that might address this? Any tips on how to possibly improve the responsiveness between the CTRL.3 knob and the motor would be greatly appreciated.

Thank you in advance for your assistance.

Hello, with the Teradek RT MOTOR.X has anyone has any luck making it a continuous monitor for a rota pola or special filter. Basically setting the motor to just have no hard stops and be able to spin continuously. Thank you for any suggestions!

Hi everyone,

I hope you're all doing well! I was wondering if anyone here has any experience with the Teradek Zoom Rocker? I'm curious to know if it's possible to change the speed of the zoom from the rocker. Also, are there any other features or things to be aware of when using this product? Any advice or feedback would be greatly appreciated.

Thank you

Hello!

I am reaching out to the forum regarding a peculiar issue that I have been facing with the Teradek RT focus control system. I have recently enabled the lens map for a prime lens for focus and iris control, but I have noticed that when I move the slider to change the iris, nothing happens. However, when I change the axis from the slider to the side-a knob, the iris changes.

I was wondering if anybody else has faced similar issues with the lens map feature of the Teradek RT focus control system. I would really appreciate if you could share your experience and suggest some solutions to fix this problem.

Thank you very much for your time and help in advance. Looking forward to your response!

Thanks,

Luke

Hello I was wondering how can I set the zoom speed on my CTRL.3 probably a stupid question but definitely can't find it haha

Can we please get normal pull out adjustable knobs to tighten the motor brackets? These are the worst and i have to shave them down to fit and they always tighten at the wrong angle so I can’t get my fingers in there. Please please!!